MOATES FLASH AND BURN DRIVER DOWNLOAD

The following table summarizes what offsets you need to use depending on chip used and file size: From File – To burn a file to a chip: Before you pop in the usb cable, be sure to download the usb files off of the moates. Once you have restarted the CPU, you have to double-check some stuff to make sure everything is tip top shape. Must program using EEC Editor.

Uploader: Shakadal
Date Added: 23 November 2015
File Size: 20.17 Mb
Operating Systems: Windows NT/2000/XP/2003/2003/7/8/10 MacOS 10/X
Downloads: 40050
Price: Free* [*Free Regsitration Required]

Once opened you can go over to the Tools tab, then go to the preference tab. Go to control panel and open the system icon. Double check addressing settings.

If you see this, you are DONE and the chip is programmed correctly! If this test passes, you can be confident that the chip was programmed correctly.

Re-erase and blank check it. Try another chip purchased from us, xenocron. The New Hardware Found prompt should pop up and then go through the wizard, but when you get to the prompt where you can change to where the file is located, select the folder where you unzipped the usb files and let it finish installation. This can be tricky — there is a whole article on it to help you.

You need to make sure the program you put in the chip ends up in the top end of the chip, so these settings matter. As a rule of thumb, tunes start at the end of the chip and count down. It makes use of the current buffer and burns the chip from the data in the buffer specified in the “Buffer Addressing” fields and burns the information to the chip at the location specified in the “Chip Addressing” fields.

  DELL C3760N COLOR LASER DRIVER DOWNLOAD

Flash & Burn Instructions

Get out your burner and a chip. Once you do have it on a COM supported, go back to the port setting tab and then select the Bits Per Second tab and change it from to then hit okay this is optional.

If instead you see something like this: Once you have moaates the CPU, you have to double-check some stuff to make sure everything is tip top shape. I first started the laptop up before I plugged in the burner to make sure that the New Hardware Found prompt would pop up.

Introduction

While the correct values are often selected, you can manually enter them. Verify Chip With Buffer – This will read the contents of the chip at and between the locations specified in the “Chip Addressing” fields and compare them against the data in the buffer at the location “Buffer Addressing” field “Start Address.

The Size of the burner is astonishing, and it comes with its own usb cable which is about 4ft long. Remove it and re-insert it to be safe. It reads the chip contents from the specified “Chip Addressing” fields and places them at the beginning of the buffer.

  AZUREWAVE AD SP400 CI DRIVER DOWNLOAD

Newer versions of TunerPro perform auto-detection which should keep you from having to worry about hurn part. To do this manually:. Also make sure the interface and emulation device is selected to AutoProm, once that is selected you can go ahead and hit ok.

Flash & Burn Program for BURN1/2/Jaybird+APU1

The following table summarizes what offsets you need ubrn use depending on chip used moatess file size: Flash n Burn usually automatically selects sane offsets based on your chip type and file size in order to place your buffer at the end of the chip, where it usually belongs.

I opened the box to find everything Bubbled wrapped to perfection. Programming chips with offsets comes into play in two situations:. Current time is 9: Without him I would have not figured out how to make this burner work with this software period.

Once you download and install this program, I suggest you restart your machine before proceeding. Once you hit it, a progress bar ane move and say if the chip was blank or not. Once you have unzipped the files, go ahead and plug in the burner.

Don’t put it in backwards!